Customizing Of The Siren Sound; Buttons Input Cutoff; Cycles Number From The Buttons Inputs; Anti-Car Jacking - MED 2200 User Manual

CUSTOMIZING OF THE SIREN SOUND

With the following procedure it is possible to choose between 2 different configurations for the
main siren:
1 Enter into the USER's programming - "siren sound customizing".
2 A musical sequence, the relighting of the LED and the continuous whistle of the buzzer
indicate the start.
3 Every time the LED, the remote control buttons are pressed or the electronic key is put on its
key socket, there is a change with the buzzer sound, indicating the different sound set for the
alarm cycle.
4 At the end turn the key
WARNING:
- The entered sound sequence is valid till the procedure will be repeated again, or till the
installer resets the system.
- The programming DOES NOT cut off during the operation.

BUTTONS INPUT CUTOFF

It cuts the doors, the boot and the bonnet buttons off - instantaneous or delayed input - keeping
the other protections (starting and volumetric radar sensor). It can also cut the additional
modules off (infra red, anti lifting etc) if they are connected to the central unit buttons inputs.
WARNING: Use the procedure just in case of a button or sensors failure when the car is
by a repair shop.

CYCLES NUMBER FROM THE BUTTONS INPUTS

It allows 3 alarm cycles of the buttons and of the additional modules (instead of a single cycle)
throughout the alarm condition and every time the alarm condition occurs.
SELF- DIAGNOSIS
The system has the self-diagnosis, that is it constantly checks its good and correct working.
BEEPS and 6 short flashings of the LED
anomalies in the system. In this case we suggest to contact your nearest installer.

ANTI-CAR JACKING

The system can control 2 different ways of working:
- MANUAL: the procedure is activated only after pressing the specific button (to be installed in
a "protected" position to avoid accidental pressures, like in case of internal cleaning), with the
ignition key turned on or off .
At releasing the button, LED switching on shortly for confirmation.
If the button is pressed when the ignition key is turned off, the procedure starts when the key
is turned on.
- AUTOMATIC: Press always the ANTI-CAR JACKING button 1 TIME (button to be installed in
an "easy to reach" position for the driver) a little before or after the turning on of the ignition
key and the signaling LED is switched on (maximum time 25-30 seconds before or after,
even if the dashboard is switched off for a very short time
At releasing the button, LED switching on shortly together with an acoustic signal from the
internal buzzer for confirmation.
If the "AUTOMATIC ANTI HI-JACK FUNCTION - ACTIVE also opening a door with working
engine" is activated and the driver opens a door (from inside with the engine started )
connected to the instantaneous central unit input he must push the anti hi-jack button within
25/30 secs. Otherwise the anti hi-jack function is activated.
If the door is kept opened it's necessary to press again the ANTI HI-JACK button.
WARNING: The procedure can be stopped only during the first warning phase
from the internal buzzer of the central unit and LED flashings) by pressing the ANTI-CAR
JACKING button.
During the following phase, the procedure can not be stopped any more.
25
[+15] ON-OFF to confirm the programming.
after the desactivation of the system indicate some
when alarming
).
6
(BEEP