Absorption Sensor; Automatic Activation Of The Engine Lock; Programmings; Additional Modules - MED 2200 User Manual

ABSORPTION SENSOR

It detects the switching on of a courtesy lamp with a capacity not lower than 5 W.
WARNING: the feeding RED wire of the central unit must be connected to the basis of the
service fuses.
- The buttons have to be always connected, because the roof lamp sometimes could not
always work correctly (burnt-out or switched off).
- If on the system activation a variable absorption occurs like when using the "blinker"
(direction indicators flashing), the sensor cuts itself out automatically till its following
activation.
- If there are some devices or electrical accessories which can be activated/desactivated
when the system is on, this sensor cannot be used.

ADDITIONAL MODULES

It is possible to integrate the central unit with some optional sensors to signalise, when the
system is active, the vehicle lifting, the shock, and all type of intrusion by the infrared or the
hyperfrequency (proximity sensor).
This last sensor is particularly indicated for the spider and the coupe vehicles, to protect the
cockpit when the windows and / or the roof are open or, combined with the traditional ultrasonic
sensor, for big size vehicles or to ptotect a second space like with vans.
The infrared are particularly indicated for campers applications.

AUTOMATIC ACTIVATION OF THE ENGINE LOCK

European Directive 95/56/EC
The
even if the system is not activated by the remote control or the electronic key.
The automatic activation can be:
Immediate on a door opening
!
minute delay if there is already an open door (please note that some vehicles consider the
door "open" till the "locking" of its door lock block).
- Trying a starting the engine does not work, the buzzer (siren) sounds continuously and the
LED and the direction indicators remain lit fixed.
- Turning the ignition key in the off position the buzzer gives some acoustic signals and the
LED some flashings.
The LED is now flashing.
- Trying a starting again, the engine does not work and the LED is lit fixed.
Desactivate the system using the remote control, the key or the emergency code.
With a 5 minute delay
!
Short BEEPS of the buzzer (siren) and some LED flashings indicate the activation of the
engine lock.
- A door opening makes the LED and the direction indicators switch on and the buzzer gives a
continuous sound till the door is closed again (maximum 5 times consecutively).
- Trying a starting the engine does not work, the buzzer (siren) sounds continuously and the
LED and the direction indicators remain lit fixed.
- Turning the ignition key in the off position the buzzer gives some acoustic signals and the
LED some flashings.
The LED is now flashing
- Trying a starting again the engine does not work and it l
Desactivate the system using the remote control the key or the emergency code.

PROGRAMMINGS

It is possible to customize the system using the USER'S programming instructions or by pairing
it with the original system using the INSTALLER'S one.
To enter into the PROGRAMMING mode:
states that the immobilizers have to get ON automatically
, if it follows the turning off of the ignition key, or with a 1
from the engine stop (ignition key OFF ).
aunches an alarm cycle.
22