Table of Contents
Advertisement
When used in a workplace, this product should be safety-tested yearly by a
qualified electrician (PAT Tested). We recommend that it is PAT tested regularly
when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for
new buildings).
At time of going to press, the average cost of electricity is £0.145 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill.
At this cost, the EH1710 will cost £0.29 per hour to run with the thermostat set to
its maximum.
If the thermostat is used to regulate the temperature the operating costs will be
lower, depending on the room temperature.
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do no use stronger detergents or solvents
as these may damage the plastic.
Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre.
2580
PAT TESTING
OPERATING COSTS
MAINTENANCE
If the mains plug needs to be replaced, proceed
as follows:
•
Connect the brown wire to the terminal
labelled "L".
•
Connect the blue wire to the terminal
labelled "N".
•
Make sure that the cord-grip is
positioned correctly (over the outer sheath of the
cable) and it fully tightened.
6
Ver. 2 - 04/14
Advertisement
Table of Contents
