Reset; Reboot System - D-Link DGS-1100-10MP Reference Manual

Reset

This window is used to reset the switch's configuration to the factory default settings.
To view the following window, click Tools > Reset, as shown below:
Select the The Switch will be reset to its factory defaults including IP address and stacking
information, and the will save, reboot option to reset the switch's configuration to its factory
default settings.
Select the The Switch will be reset to its factory default except IP address, and then will save,
reboot option to reset the switch's configuration to its factory default settings. This option will
exclude the IP address from being changed.
Select the The Switch will be reset to its factory defaults including IP address option to reset
the switch's configuration to its factory default settings.
Click the Apply button to initiate the factory default reset and reboot the switch.
NOTE: Performing a factory reset in one version of the interface (Standard Mode
or Surveillance Mode) will cause settings to be reset in the other version of the
interface.

Reboot System

This window is used to reboot the switch and alternatively save the configuration before doing so. To
view the following window, click Tools > Reboot System, as shown below:
When rebooting the switch, any configuration changes that was made during this session, will be lost
unless the Yes option is selected when asked to save the settings.
Click the Reboot button to alternatively save the settings and reboot the switch.
D-Link DGS-1100 MP/MPP Series Switch User Manual
Figure 15-6 Reset window
Figure 15-7 Reboot System window
51