Start-Up And Operation; Start-Up - ABB AquaMaster 3 FET200 User Manual

AquaMaster 3 FET200
Electromagnetic flowmeter Transmitter

4 Start-Up and Operation

Warning.

The battery pack used by AquaMaster3 may present a risk of fire or chemical burns if mistreated.
Do not recharge, disassemble, heat above 100 °C (212 °F) or incinerate.

Replace battery pack with an ABB-supplied part only. Use of another battery may present a risk of
fire or explosion.

Dispose of all battery packs promptly. Keep away from children.

Dispose of battery packs in accordance with local regulations.

Where possible, recycle used batteries.

Contact the local environmental authority for further information regarding disposal or recycling
schemes for used batteries.

Operation at extremes of temperature significantly shortens the battery capacity and life – see
Specification, page 34.

4.1 Start-up

To start the AquaMaster3 for the first time:
1. Connect the external power source; mains / battery or renewable power source – see Section 3.5,
page 25.
2. Remove transportation label.
3. Cover the display area for a few seconds.
4. Uncover the display area. The display is activated, the AquaMaster3 performs a self-test and begins
communication with the sensor.
A successful connection is indicated by the message 'Pass' in the display window and normal
flowmeter operation commences.
Notes.

If the display shows 'Err 1', check the sensor wiring. If the fault is rectified, the transmitter restarts
automatically.

If the display shows 'Err 2' or 'Err 3', contact ABB.
OI/FET200–EN Rev. I
4 Start-Up and Operation
29