AquaMaster 3 FET200
Electromagnetic flowmeter Transmitter
2.4.2 Connecting a Remote Antenna
Referring to Fig. 2.16:
1. Remove the cover
2. Gently push the antenna plug
Fig. 2.16 Connecting a Remote Antenna
2.4.3 Installing a SIM Card
Referring to Fig. 2.17:
Note. Step 1 is applicable only to remote- and close-coupled transmitters.
1. Remove the transmitter from its mounting point.
Note. Step 2 is applicable only to integral transmitters.
2. Remove 4 x 4 mm Hex fixing screws
3. Use water to wash off any loose dirt from the case and dry the area around the SIM card cover.
4. On the back of the transmitter, unscrew and remove cover
5. If the SIM card is being changed, ensure the GSM Engine is off before removing the card by reading
>368 (see COI/FET2XX–EN) and ensuring the status reported is Off.
6. Carefully lift the right-hand edge of holder
12
A
from the socket on top of the transmitter.
B
into the socket, then twist the screw ring clockwise until locked.
A
and remove the transmitter.
AquaMaster 3
B
protecting SIM card holder
C
outwards.
2 Mechanical Installation
C
.
OI/FET200–EN Rev. I