Table of Contents
Advertisement
Ford 4.6 and 5.4 Liter
NO DISPLAY WITH KEY ON – If you should get no display when
turning the key on, check all of your fuses and make sure your battery
is fully charged. Disconnect and reconnect the OBD-II cable to ensure
the Evolution restarts properly. If the unit restarts but fails to stay on,
or fails to turn on when the key is on, there is most likely a
communications issue. Contact Edge Products Technical Support for
further assistance.
NO START – If you experience a "No-Start" condition after
programming your PCM, return to the Power Programming menu and
select Return to Stock. This will allow the Evolution to reprogram the
PCM with the factory calibration and recover the PCM. If, after
reprogramming, you still have a "No-Start" condition, contact Edge
Products Technical Support. A member of our support team can
further instruct you on possible recovery procedures.
ERROR CODE 0xF1 (AFTER PCM READ) – If you are receiving
this error code right after the Evolution reads your PCM, check for
updates using the Fusion® software. If the problem continues, contact
Edge Products Technical Support.
ERROR CODE 0xF1 (IN CUSTOM MENU) – If you are receiving
this error code while trying to configure your custom options,
disconnect from the OBDII connector, turn the key to the ON position,
and plug the Evolution back in. After getting to the main screen (past
Intro and Disclaimer), wait 15 seconds. This will give your unit time
to load parameters it needs to perform the custom changes. You
should now be able to perform your custom changes.
TROUBLE CONNECTING TO THE FUSION SOFTWARE – If
you are having trouble connecting to the Fusion software, the first
thing to check is whether or not you have HotSync on your computer.
HotSync is software used to sync your PDA/Palm to your computer. If
you do have HotSync on your computer, follow these steps:
1. Right click on the HotSync icon that looks like this:
2. You will get a menu that looks like this:
40
Evolution
Hide quick links:
Advertisement
Table of Contents
