Diagnostic Led Header; Table 7: 914-Hde Diagnostic Led Header Pinout; Figure 3-10: Diagnostic Led Header - Focal 914-HDE User Manual

3.7 Diagnostic LED Header

The 914-HDE card includes a 10-pin header capable of driving 8 LEDs. This is useful for LED integration into
an enclosure. Each LED pin is driven low to turn on an LED, and includes a 267 ohm resistor in series to limit
the current draw. Maximum current draw is 8 mA.
This header may optionally become an input via the diagnostic GUI with firmware revisions greater than B1.
The LED header is FCI P/N 20021521-00010T1LF, and the mating part is FCI P/N 20021444-00010T1LF. This
can be used with most 0.050" (1.27mm) spacing ribbon cables.
Pin Name
1
3.3V
2 LINK
3
LINK FAULT
4 VIDEO
5 ETHERNET
6 SER1 RX
7 SER1 TX
8 SER2 RX
9 SER2 TX
10 GND
Focal Technologies Corporation
A Moog Inc. Company

Table 7: 914-HDE Diagnostic LED Header Pinout

3.3V
This pin can be used to drive the LEDs, Maximum current is 0.5A.
Indicates a valid optical link is being received. Active low.
Indicates that insufficient optical power is present. Active low.
Indicates a valid video signal is present when lit. Active low.
Indicates that an Ethernet link is established locally. Active low.
Flashing LED indicates serial channel 1 receive activity. Active low.
Flashing LED indicates serial channel 1 transmit activity. Active low.
Flashing LED indicates serial channel 2 receive activity. Active low.
Flashing LED indicates serial channel 2 transmit activity. Active low.
Ground

Figure 3-10: Diagnostic LED Header

Model 914-HDE User Manual
Description
Document Number: 914-0601-00 Rev. 4.0
3-10