Adjustment Method; Test Mode Setting Method; Initialization Method; Method Of Displaying Version Of Microcomputer - JVC XV-SA600BK Service Manual

XV-SA600BK/XV-SA602SL

3.1 Test mode setting method

(1) Take out the disc and close the tray.
(2) Unplug the power plug.
(3) Insert power plug into outlet while pressing both "PLAY" key and "STOP" key of the main body.
(4) The player displays " TEST
(5) When the power supply is turned off, test mode is released.
The mode changes as follows whenever the "CHOICE" key of remote controller is pushed in test mode.

3.2 Initialization method

Please initialize according to the following procedures when microprocessor or pick-up is exchanged and when the
up-grade is done.
(1) Makes to test mode.
(2) "PAUSE" key of the main body is pushed.
(3) A green progressive indicator lights when about a few seconds pass. Then, it is initialization completion.
*Please make scan mode test mode in the state of interlaced scan mode.
(State of progressive indicator turning off)

3.3 Method of displaying version of microcomputer

(1) Makes to test mode and initializes
(2) When "CHOICE" key of remote controller is pushed once, the figure is displayed on the FL display as follows.
FL Display microcomputer (IC2)
Front end microcomputer (IC401)
4 key (laser of CD)
5 key (laser of DVD)
TV DVD
STANDBY/ON
OPEN/
CLOSE TV DVD
TV1 TV2 TV3
1 2 3
TV4 TV5 TV6
4 5 6
TV7 TV8 TV9
7 8 9
UP key
TV-/-- TV0 MUTING
10 0 +10
TITLE/ TV/VIDEO
RETURN PAGE GROUP CANCEL
(for firmware upgrade)
CH
+
VOL- VOL+
ENTER
CH
-
CHOICE key
PREVIOUS NEXT
CLEAR SELECT STROBE
(switch of mode)
SLOW - SLOW+
REPEAT SUB TITLE AUDIO VFP
fs/Rate PROGRESSIVE
SCAN
DIGEST ANGLE ZOOM
3D
PHONIC AMP VOL
STOP key (laser OFF)
RM-SXV011J
REMOTE CONTROL
16
SECTION 3

Adjustment method

" on the FL display. " " means the player version.
TEST_ _ -----------------------
_ _ ---------------------
FL display becomes all lighting ---
---------
CHECK ---------------------------------
EXPERT --------------------------------
FL Display (example)
_ _ 4 1 _ 7 3 _ 6 5 _ _
POWER key
STANDBY/ON
STANDBY/ON
Becomes test mode
Version of microcomputer
Confirmation of FL display
Device key index
Check mode
Not use mode
Decoder part (IC509)
STOP key
(for test mode)
(for test mode and jitter value)
DVD AUDIO/DVD VIDEO/SUPER VCD/VCD/CD PLAYER
OPEN/CLOSE
PROGRESSIVE DVD AUDIO
PROGRESSIVE
FL Display
Indicator
(for initialize)
PLAY key
STOP PLAY PAUSE SKIP
PAUSE key
(for initialize)