Husqvarna K 760 Workshop Manual page 7

4
1
3
1
1
3
7
DISMANTLING INTO BASIC MODULES
2
4
!
2
2
4
Air filter
1. Loosen the guard's three screws and
remove the guard.
2. Loosen the two screws that hold
the filter bottom.
3. Lift up the filter bottom together with
the filter.
4. Press the filter out of the filter bottom.
Cylinder cover
1. Loosen the four screws on the cylinder
cover.
Press together the rubber seal's collar
so that the cylinder cover can be lifted
off.
2. NOTE! When reassembling the rubber
seal must be drawn up through the cover
and the collar then adjusted to fit
correctly against the cover.
Carburettor
1. The carburettor unit is attached to the
cylinder by a single screw. Loosen the
screw.
2. Lift out the carburettor unit. Detach
the petrol hose and the hose to the "air
purge" from the carburettor.
Tip: Tape the throttle control in the
full throttle position to improve access
to the throttle rod's attachment on the
throttle control.
3. Pull the throttle rod out of the con-
trol.
4. The entire carburettor unit can now be
lifted out.