Husqvarna K 760 Workshop Manual page 15

6
1
3
1
15
IGNITION SYSTEM
2
4
2 3
502 51 34-02
Test of short circuit cable and
stop switch
Try using a measuring instrument or the
following simple solution: Connect a
battery in series with a test lamp to the
short-circuit cable and engine body.
Observe the test lamp while testing the
function of the stop switch. With the
stop switch in operating position the
lamp must be out.
If the lamp is on – check first that the
short circuit cable insulation is not
damaged and is providing contact to the
engine body. Now check the stop switch.
Removing the stop switch
1. Remove the cable lug and the screw.
2–4. Bend the control to the left with a
large screwdriver and pull the switch to
the right side first.
Mounting the stop switch
1. Press the switch to the snap lock.
2. Press in the right side.
3. Press in the left side to ensure the snap
fastener locks the switch. Fit the screw
and cable lug.
Replacing the ignition module
The ignition module is secured by two
screws to the engine body.
When assembling the new module, the
flywheel with magnets is turned towards
the ignition module.
Place air gap gauge (.01 in./0.3 mm)
502 51 34-02 against the magnets and fit
the new module in position.
The screws should be tightened to a
torque of 6.6–8.1 lbf·ft/9–11 Nm.