K 760 Cut-N-Break - Husqvarna K 760 Workshop Manual

K 760 Cut-n-Break

K760 Cut-n-Break
The special version of the K760, Cut-n-Break, can handle
cutting depths up to 16 in./400 mm by cutting and
breaking in steps. Dual cutting blades with belt drive
between the
blades makes it possible to develop this handheld machine
with an extremely deep cutting depth.
The machine body is identical to the all-round cutter
K760, with a few exceptions.
Crankcase
The crankcase half on the clutch side has been specially
manufactured for this machine, while the crankcase half
on the flywheel side is identical for both machines.
The special crankcase half has two studs for attaching
the cutting arm.
The splash guards have two mounting points on the
crankcase half.
Clutch drum
To ensure the smallest possible distance between the
blades, the machine has a narrow V-belt and a customised
drive wheel for this.
Service work
The service work that is relevant for the cutting head is
very limited and simple to perform. In addition to re -
placing the blade, the service needs are limited to simply
replacing the belt and the bearing for the blade.
Removing the cutting head
For all the work on the cutting head, except changing
the blade and bearing it is easiest to first dismantle the
complete cutting head, and then dismantling it into its
component parts.
19
54