Husqvarna K 760 Workshop Manual page 46

CUTTING HEAD 15
Belt pulley
Work procedure
In order to handle the belt pulley with
the retarder as a completely joined unit, it
is important that dismantling, as well as
fitting, is made in the right order.
Warning
Do not make the mistake of removing
the screws that are marked in the illustra-
tion. If the belt pulley is dismantled in
this way, the retarder will break apart into
its component parts.
Remove the belt pulley
Turn the belt pulley so that the three
screws that hold the brake drum to the
bearing housing become accessible.
Remove the brake drum screws with a
screwdriver, Phillips PH 2.
Hint: A magnetic screwdriver makes
work easier.
PH 2
Lock the belt pulley with a mandrel or a
screwdriver. Remove the belt pulley's
centre screw. You can now lift off the
belt pulley with retarder.
The illustration on the right shows the
retarder in the belt pulley.
46