Yale YRD246 Installation And Programming Instructions page 16

Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it restricts all user (except
Master) PIN code access. When attempting to enter a code while the unit is in Lockout, the
will appear on the screen.
Automatic Re-lock Time: After a successful code entry and the unit unlocks, it will automatically re-lock after
thirty (30) seconds.
Inside Indicator Light: Located on the interior escutcheon. Shows active status (Locked) of lock and can be
enabled or disabled in the
Language Setting Mode: Choosing English (1), Spanish (2) or French (3) becomes the (default) setting for the
lock's voice prompts.
Low Battery: When battery power is low, the Low Battery Warning indicator flashes
completely lost, use the 9Volt battery override. To use the 9V battery override apply 9V battery, in either direction,
to terminals below the touchscreen for backup power option. Wake up the lock and enter your pin code to unlock
the door.
Master PIN Code: The Master
prior to programming the lock. The Master code will also operate (unlock/lock) the lock.
Network Module Setting: With the optional Network Module installed, this setting becomes available thru the
Main Menu (7) and allows the lock to connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-
lock duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is
valid PIN code will re-lock the lock.
Previous: While in Menu Mode, pressing this icon cancels the current operation and returns the user to the
previous step.
Privacy Mode: Privacy mode is disabled by default. Enable Privacy mode by pressing the privacy button for 4
seconds to put the lock in do-not-disturb mode (all pin codes are disabled).
Shutdown Time: The unit will shutdown (flashing
wrong code entry limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User PIN Code: The User code operates the lock. Maximum number of user codes is 250 with Network Module;
without Network Module, maximum is 25 user codes. Note: When deleting User
User Number (not PIN code) being deleted.
Volume Setting Mode: The volume setting for
be set to High (1) or Silent (3)
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid
down and not allow operation.
Advanced Lock Settings (Main Menu selection #3).
PIN code is used for programming and for feature settings.
RED
PIN code verification is set to
for quiet areas.
P/N YRL KFTSINSTL FUL -
) for sixty (60) seconds and not allow operation after the
Low (2)
16
- Rev E
RED locked padlock
RED . If battery power is
It must be created
not in use (disabled), any
PIN code(s), screen will display
by default; otherwise it can
PIN code, the unit will shut