Reflector Configuration (Model 2000 Only) - Netscout LinkRunner AT 1000 User Manual

Reflector Configuration (Model 2000 only)

This screen is used to configure the LR-AT 2000 to act as a
reflector for performance tests conducted by other
NETSCOUT testing devices.
The LR-AT 2000 can reflect jumbo frame sizes up to 9600
bytes.
Select Tools > Reflector. The default or pre-configured
Reflector settings are displayed below
Figure 11. Reflector Settings Screen
Note
Select Configure.
Figure 12. Reflector Default Configuration Screen
The LR-AT 2000 must be configured to:
MAC + NETSCOUT - This filter setting allows the LR-AT 2000
to only reflect packets when the destination MAC address
field matches the LR-AT 2000's own MAC address and
NETSCOUT payload.
MAC + IP - This swap setting allows the LR-AT 2000 to swap
the source and destination MAC and IP addresses for packets
that are reflected back to the analyzer.
Any other Reflector setting may cause undesired traffic
on your network.
16
Setting Up the Tester
Note