FLASHFORGE 3D PRINTER CREATOR PRO Quick Start Manual page 6

12. Elevate the build plate to its limit with care.
14. Congratulations! You've finished the



unpacking process. (Tip: Save your




Flashforge Creator Pro packaging for




future transportation and storage. )
1. Place the two anterior angles of the lid into
the corresponding front slots.
13. Take the bottom protective foam from



the printer and then lower the build plate
back.
Installation and Dismantlement
Anterior Angle
2. Slightly squeeze the two relief angles to place
them into the corresponding rear slots.
To remove the lid, squeeze the relief angles to
remove them from the slots.
05
Relief Angle
Anterior Angle