FLASHFORGE 3D PRINTER CREATOR PRO Quick Start Manual page 4

1. Open box and remove top foam piece.
3. Firmly grasp the two side handles of




Flashforge Creator Pro. Lift it out from the




carton and place it on a stable surface.
5. The Flashforge Creator Pro and its




accessories shall be displayed in front




of you.
Unpacking
2. The foam should contain: two filament guide
tubes, two piece of build tape, one Flashforge
leveling card and one Quick Start Guide.
4. Remove the packing bag. And then
remove the tape and plastic wrap for
protecting the front door.
6. Take the dual extruder out and place the
extruder carefully because the extruder
cable bunch is short.
03