Panasonic CS-NZ9SKE Service Manual page 39

Hide thumbs Also See for CS-NZ9SKE:
Table of Contents

Advertisement

12.3.6
How to Take Out Front Grille
Please follow the steps below to take out front grille if
necessary such as when servicing.
1
Set the vertical airflow direction louvers to the
horizontal position.
2
Remove the 2 caps on the front grille as
shown in the illustration at right, and then
remove the 3 mounting screws.
3
Pull the lower section of the front grille
towards you to remove the front grille.
When reinstalling the front grille, carry out
above step 2 - 3 in the reverse order.
12.3.7
Auto Switch Operation
The below operations will be performed by pressing the "AUTO" switch.
1
AUTO OPERATION MODE
The Auto operation will be activated immediately once the Auto Switch is
pressed and release before 5 sec..
2
TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the Auto Switch is pressed
continuously for more than 5 sec. to below 8 sec..
A "pep" sound will occur at the fifth sec., in order to identify the starting of
Test Run operation.
3
HEATING TRIAL OPERATION
Press the "AUTO" switch continuously for more than 8 sec. to below 11 sec. and release when a "pep pep"
sound is occured at eight sec. (However, a "pep" sound is occurred at fifth sec..) Then press Remote
controller "A/C Reset" button once.
Remote controller signal will activate operation to force heating mode.
4
REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of Remote controller receiving sound can be change over by the following steps:
a) Press "AUTO" switch continuously for more than 16 sec. to below 21 sec..
A "pep", "pep", "pep", "pep" sound will occur at the sixteenth sec..
b) Press the "A/C Reset" button once. Remote controller signal will activate the Remote controller sound
setting mode.
c) Press the "AUTO" switch once to select Remote controller receiving sound ON/OFF. A "peep" sound
indicates receiving sound ON, and a "pep" sound indicates receiving sound OFF.
12.3.8
Outdoor Unit Drain Water
Water will drip from the basepan hole area during
defrost function.
To avoid water dripping, do not stand or place
objects at this area.
12.3.9
Installation of Air Purifying Filter
1
Open the front panel.
2
Remove the air filter.
3
Put the air purifying filter into place as shown
in illustration.
Vane
(Move the vane
to downward)
Air filter
39
Screw
Front
grille
Cap
Hose
Air purifying fi lter 7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs-qz9skeCu-qz9skeCu-nz9skeCs-nz12skeCu-nz12ske

Table of Contents