Page 1
Operating Instructions Air Conditioner DEICE Model No. Indoor Unit Outdoor Unit CS-NZ25VKE CU-NZ25VKE CS-NZ35VKE CU-NZ35VKE Operating Instructions 2-41 Air Conditioner CS-NZ50VKE CU-NZ50VKE Before operating the unit, please read these operating CS-QZ25VKE CU-QZ25VKE instructions thoroughly and keep them for future reference.
Page 2
A new built-in Network Adaptor that allows you to control your heatpump from everywhere. Use remote control within 8 m from the remote control receiver of the indoor unit. Quick Guide Inserting the batteries Clock setting 1 Press and set CLOCK the time 1 Pull out the back cover...
Thank you for purchasing Panasonic Air Conditioner. Table of contents Safety precautions ....4-16 System Overview ....17 How to use ......18-29 To learn more ......30 Cleaning instructions ....31 Troubleshooting ....32-34 Information ......35-36 Copyright ......37-41 Accessories •...
Safety precautions To prevent personal injury, injury to others WARNING or property damage, please comply with the following: Incorrect operation due to failure to follow instructions below may cause harm or damage, Indoor unit and outdoor unit the seriousness of which is classiÞ ed as below: This appliance can be used by This appliances is not intended for accessibility children aged from 8 years and above...
Page 5
Do not expose yourself directly to cold If the supply cord is damaged, it must air for a long period to avoid excess be replaced by the manufacturer, cooling. service agent or similarly qualiÞ ed persons in order to avoid a hazard. Do not sit or step on the unit, you may fall down accidentally.
Page 6
Safety precautions After a long period of use, make CAUTION sure the installation rack does not deteriorate to prevent the unit from falling down. Indoor unit and outdoor unit Do not wash the indoor unit with water, Remote control benzine, thinner or scouring powder to Do not use rechargeable (Ni-Cd) avoid damage or corrosion at the unit.
Page 7
Check the following requirements WARNING before and during operation from outside: • Do inform the inside person of the This appliance is Þ lled with R32 air conditioner operating setting’s (mild ß ammable refrigerant). condition. If the refrigerant is leaked and (This may cause harm to human body exposed to an external ignition due to sudden changes of outside...
Page 8
Safety precautions • Any part of refrigerating circuit Precaution for using R32 (evaporators, air coolers, AHU, refrigerant condensers or liquid receivers) or The basic installation work procedures are the piping should not be located in the same as conventional refrigerant (R410A, R22) proximity of heat sources, open models.
Page 9
c) Able to understand and to apply in 1. Installation (Space) practice the requirements in the • Product with ß ammable refrigerants, national legislation, regulations shall be installed according to and Standards; and, the minimum room area, Amin d) Continuously undergo regular and (m²) mentioned in Table A of the further training to maintain this Installation Instructions.
Page 10
Safety precautions 2. Servicing 2-2. Work • Prior to beginning work on systems 2-1. Service personnel containing ß ammable refrigerants, • The system is inspected, regularly safety checks are necessary to supervised and maintained by ensure that the risk of ignition a trained and certiÞ...
Page 11
2-3. Checking for presence of 2-5. No ignition sources refrigerant • No person carrying out work in • The area shall be checked with an relation to a refrigerating system appropriate refrigerant detector prior which involves exposing any pipe to and during work, to ensure the work that contains or has contained technician is aware of potentially ß...
Page 12
Safety precautions 2-7. Checks to the refrigerating 2-8. Checks to electrical devices equipment • Repair and maintenance to electrical • Where electrical components are components shall include initial safety being changed, they shall be Þ t checks and component inspection for the purpose and to the correct procedures.
Page 13
3. Repairs to sealed components 4. Repair to intrinsically safe • During repairs to sealed components, components all electrical supplies shall be • Do not apply any permanent inductive disconnected from the equipment or capacitance loads to the circuit being worked upon prior to any without ensuring that this will not removal of sealed covers, etc.
Page 14
Safety precautions 7. The following leak detection 8. Removal and evacuation methods are deemed • When breaking into the refrigerant acceptable for all refrigerant circuit to make repairs – or for systems any other purpose – conventional • No leaks shall be detected when procedures shall be used.
Page 15
9. Charging procedures 10. Decommissioning • In addition to conventional • Before carrying out this procedure, charging procedures, the following it is essential that the technician requirements shall be followed. is completely familiar with the -Ensure that contamination of equipment and all its details. different refrigerants does not occur •...
Page 16
Safety precautions i) Do not exceed the maximum • Cylinders shall be complete with working pressure of the cylinder, pressure relief valve and associated even temporarily. shut-off valves in good working order. j) When the cylinders have been • Recovery cylinders are evacuated Þ...
However, there is no guarantee that the APP will work well with all Android OS version. • The Network Adaptor is designed speciÞ cally as a terminal for “Panasonic Comfort Cloud” app. • The Wireless LAN network coverage must reach the air conditioner installation location.
How to use To adjust airß ow direction To adjust vertical airß ow direction Upper direction AIR SWING DEICE • Do not adjust the ß ap by hand. Indicator POWER TIMER DEICE +8/15°C HEAT • For lateral direction, it is manually adjustable as shown.
Page 19
To connect network • Press to communicate with the home wireless LAN access point. • Wireless LAN LED blinks to indicate the connection status to home access point. Fast blink The unit is establishing the connection. Slow blink The unit is not securing the connection. No blink (stays on) The unit has established the connection.
Page 20
• There is no charge for using this application. However, other charges may be incurred for connection and operation. Starting “Panasonic Comfort Cloud” Create New Panasonic ID Use “Panasonic Comfort Cloud” app as an option to control the air conditioner. • For new user, select Create new Panasonic Login ID to register.
Page 21
• ConÞ rm the Wireless LAN of the smartphone is activated. • Smartphone and air conditioner should be connected to the same wireless router. Add new air conditioner device • Air conditioner need to be registered before using “Panasonic Comfort Cloud” app. Home Add new device...
Page 22
How to use Setting connection network Ensure Wireless LAN LED is ON, point When Wireless LAN LED is blinking, the remote control to air conditioner and select the preferred connection setup press Wireless LAN button until the mode. Wireless LAN LED changed to blinking. Connection Guide Connection Guide Step 1...
Page 23
Connection network using WPS mode (method 1) Press the “WPS” button from the Ensure Wireless LAN LED is ON. Press router that will be connected to an air and hold the Wireless LAN button conditioner. for 5 seconds until “1” is shown on the •...
Page 24
CANCEL Next Cancel Cancel Copy the password for later use. Select “Panasonic-CS-wirelessAP” from smartphones Wireless LAN setting and enter the copied password. Return to “Panasonic Comfort Cloud” app. Copy password and next Cancel (go back to previous screen) ACXF55-24700_FULLSET.indb 24...
Page 25
Select the SSID of your wireless router. Enter the password to connect the air conditioner to the wireless router. Connection Guide Connection Guide Connection Guide Connection Guide Connection Guide Step 1 Step 2 Step 3 Step 1 Step 2 Step 3 Step 1 Step 2 Step 3...
Page 26
How to use Select the air-conditioner and set the password Select the air conditioner model to Set a password for new air conditioner register the device. model to complete the registration. Connection Guide Connection Guide Step 1 Step 2 Step 3 Step 1 Step 2 Step 3...
Page 27
• By registered the new name of air conditioner, the function of “Panasonic User’s manual can be Comfort Cloud” app is ready to be used. found under Menu tab.
Page 28
It is recommended to name each of the registered air conditioner “Panasonic Comfort units for easy to distinguish. Cloud” app. Register additional Download “Panasonic Comfort Cloud” app and create new user to control the Panasonic ID. Network Adaptor. Follow initial setting. Once the air conditioner is registered, input the preset device password (set by Þ...
Page 29
“Owner” and select “Change router settings”. Change of Ensure the smartphone compatability. Install “Panasonic smartphone’s model. Comfort Cloud” app and login using your Panasonic login ID and password. Complete by initial connection setup. Change of control Change the control board and then, use “Panasonic Comfort board of the indoor Cloud”...
To learn more... Operation mode HEAT : The POWER indicator blinks at the initial stage of this operation. Unit takes a while to warm up. • For system which HEAT mode has been locked, if operation mode other than HEAT is selected, the indoor unit stops and the POWER indicator blinks. •...
Cleaning instructions To ensure optimal performance of the Indoor unit unit, cleaning has to be carried out at regular intervals. Dirty unit may cause Air Purifying Filter malfunction and you may see error code Aluminium Þ n “H 99”. Please consult authorised dealer. Front panel •...
Troubleshooting The following symptoms do not indicate malfunction. Symptom Cause POWER indicator blinks before the unit is • This is a preliminary step in preparation for the switched on. operation when the ON timer has been set. When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time.
Page 33
When... The remote control is missing or a malfunction has occurred 1. Raise the front panel. 2. Press the button once to use in AUTO mode. 3. Press and hold the button until you hear 1 beep, then release to use in forced COOL mode.
Page 34
Troubleshooting How to retrieve error codes If the unit stops and the TIMER indicator blinks, use the remote control to retrieve the error code. Press for Press until you hear beep 5 seconds TIMER sound, then write down the error code Press for 5 TIMER Turn the unit off and...
Information Information for Users on Collection and Disposal of Old Equipment and Used Batteries Your product is marked with this symbol. This symbol means that electrical and electronic products shall not be mixed with unsorted household waste. Do not try to dismantle the system yourself: the dismantling of the product and of other parts must be done by a qualiÞ...
Page 36
Information Firmware Update Function This product has functionality for connecting to the Panasonic Þ rmware update server over the Internet to automatically update the device Þ rmware to the latest version. To update the Þ rmware, the device will do check, once per day, whether its Þ rmware is the latest version after power up.
“Software License” menu on this product. transformation or translation of a Source form, including but not limited At least three (3) years from delivery of this product, Panasonic will give to compiled object code, generated documentation, and conversions to to any third party who contacts us at the contact information provided other media types.
Page 38
Copyright Contributor that are necessarily infringed by their Contribution(s) alone acts) or agreed to in writing, shall any Contributor be liable to You or by combination of their Contribution(s) with the Work to which such for damages, including any direct, indirect, special, incidental, or Contribution(s) was submitted.
Page 39
The FreeRTOS GPL Exception Text: For example, if you distribute copies of such a program, whether gratis or for a fee, you must give the recipients all the rights that you Any FreeRTOS source code, whether modiÞ ed or in it’s original release have.
Page 40
Copyright conditions, and telling the user how to view a copy of this License. 5. You are not required to accept this License, since you have (Exception: if the Program itself is interactive but does not normally not signed it. However, nothing else grants you permission to modify print such an announcement, your work based on the Program is or distribute the Program or its derivative works.
Page 41
NO WARRANTY You should also get your employer (if you work as a programmer) or your school, if any, to sign a “copyright disclaimer” for the program, if 11. BECAUSE THE PROGRAM IS LICENSED FREE OF CHARGE, necessary. Here is a sample; alter the names: THERE IS NO WARRANTY FOR THE PROGRAM, TO THE EXTENT PERMITTED BY APPLICABLE LAW.
Page 42
English Declaration of Conformity (DOC) Hereby, “Panasonic Corporation” declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU The full text of the EU declaration of conformity is available at the following internet address: http://www.ptc.panasonic.eu/...
Need help?
Do you have a question about the CU-NZ25VKE and is the answer not in the manual?
Questions and answers