Master Station; Fp3 Transmitter Master Unit - Panasonic FP3 Technical Manual

2-2. Master Station

1. FP3 Transmitter Master Unit

1) Parts terminology
<Front>
MASTER
0 8
1 9
2 A
3 B
TRANSMITTER
4 C
MASTER
5 D
6 E
7 F
SLAVE UNIT NO
COM.
ALARM
↕
INPUT
DSP SW.
OUTPUT
1
2
3
MODE
4
5
SW.
6
7
8
ON OFF
+
I
-
F.G.
+
II
-
Station monitor LEDs:
1
Operation monitor LEDs:
2
Selector for station monitor LEDs:
3
Operation mode selector:
4
RS485 interface:
5
Mounting screw:
6
Connector:
7
Station monitor LEDs
1
Operation monitor LEDs
2
Selector for station
3
monitor LEDs
Operation mode selector
4
RS485 interface
5
LEDs that monitor the slave stations (station number 0 to F) connected to
the FP3 transmitter master unit.
-When ON:
-When flashing: A communication error at this slave station number
-When OFF:
Indicate the operation and communication status of the MEWNET-TR
system. See following page.
Selects the unit type (input or output) of station monitor LEDs.
Input position (INPUT):
Output position (OUTPUT): Status of slave station (FP I/O transmitter
The selector's upper state is "INPUT (
"OUTPUT (
Selects the MEWNET-TR communication conditions and sets the I/O
addresses. See following page.
Interface for MEWNET-TR communications.
A screw for attaching the unit to a master or expansion backplane.
Connects to the slot on the master or expansion backplane.
<Rear>
Connected to a slave station
Not connected to a slave station
Status of slave station (FP I/O transmitter
unit) input type is indicated by station
monitor LEDs.
unit) output type is indicated by station
monitor LEDs.
)."
2-2. Master Station
Mounting screw
6
Connector
7
Unit tabs
)" and the lower state is
13