Introduction - Culligan Iron-Cleer Installation And Operation Instructions With Parts List

Models from 2007
Hide thumbs Also See for Iron-Cleer:
Table of Contents

Advertisement

This system and its installation must comply with state and local regulations. The System is ONLY to be
supplied with cold water.
The Culligan
Iron-Cleer
water filters have been tested and certified by WQA against WQA-200 for the
®
®
effective reduction of iron up to 1,400 gallons for 10" units and 2,000 gallons for 12" units.
For installations in massachusetts, the Commonwealth of massachusetts Plumbing Code 248 CmR
shall be adhered to. Consult with your licensed plumber for installation of this system. The use of
saddle valves are not permitted.
Safe Practices
Throughout this manual there are paragraphs set off by special headings.
Notice: Notice is used to emphasize installation, operation or maintenance information which is important, but does not present
any hazard. Example:
Notice: The nipple must extend no more than 1 inch above the cover plate.
Caution: Disassembly while under water pressure can result in flooding.
Caution: Caution is used when failure to follow directions could result in damage to equipment or property. Example:
Warning! Electrical shock hazard! Unplug the unit before removing the timer mechanism or cover plates!
Warning: Warning is used to indicate a hazard which could cause injury or death if ignored. Example:
Serial Numbers
The control assembly serial number is top center on the rear of the timer plate.
The media tank serial number is on the top of the sideshell of the tank.
Do not remove or destroy the serial number decals. They must be referenced on requests for warranty repair or
replacement.
This publication is based on information available when approved for printing. Continued refinement of design could cause changes
that may not be included in this publication.

Introduction

Introduction
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents