Auto-Log Feature - Cygnus M5-C4P Operating Manual

M5-CYG4P-M-01_Iss5.doc
2. ...the thickness measurement is
added to the list, in this example
it's at 'P1' as it's the first
measurement.
3.
The 'number of records'
indication changes colour to light
blue for a second after wards to
indicate the measurement has
just been logged ok.

Auto-Log Feature

The gauge has an Auto-Log feature that will automatically log
thickness measurements when the measurement remains stable
for two seconds. This means the operator can log measurements
using one hand.
See Auto-Log on page 95 to turn the Auto-Log feature On or Off.
The Auto-Log sequence is as follows;
1. Place the probe on the surface and obtain a measurement
2. Hold the probe still to ensure the measurement remains
stable..
3. After 2 seconds of stable measurement the value will be
Auto-Logged
4. Remove the probe from the surface and wait until the
'number of records' indication turns from blue to grey before
taking the next measurement, this is about 1 second.
Cygnus 4+ Operating Manual
71