Additional Procedures; To Reset The Remote Control - Philips intelligent remote control User Manual

Additional procedures

To reset the remote control

The remote control's reset button is accessible through a small hole on the back
of the remote control. Under normal circumstances, you should never need to
reset the remote control. However, if the display freezes or you notice other
unusual behavior, you might need to use the reset button to get the remote
control working again.
To reset the remote control:
•
Using the tip of an unfolded paperclip, gently press the Reset button
located deep within the remote control unit.
You might feel some resistance when you press down. When you have pressed
the Reset button, the remote control starts up. After a few seconds, the remote
control beeps, indicating that it's ready to use.
Reset button
You will not lose custom commands and macros that you have saved.
NOTE
However, if you were making changes to the remote control in a mode other
than Use, and you quit before you saved changes, you will lose the changes.
Additional procedures 71