Learning Commands From Other Remote Controls (Learn Mode) - Philips intelligent remote control User Manual

Learning commands from other remote controls
(Learn mode)
You teach the remote control to operate a device by assigning the correct
commands to the buttons on the display, the direct-access buttons, and the Left
and Right buttons. The remote control learns these commands by receiving
infrared signals directly from your existing remote controls. The remote control
receives these signals through its learning eye , the small hole at the bottom of
the case.
The following illustration shows which buttons can "learn" commands.
Instructions for teaching these buttons are in the next sections.
Control panel
buttons
The device buttons on the Home panels can't be programmed directly.
NOTE
To assign commands to the buttons in Home, you must program the items on
the Device menu; for instructions, see "To program an item on the Device
menu" on page 34. The commands you assign to the Device menu will
automatically be assigned to the buttons in Home.
30 Chapter 3—Customizing the remote control
Buttons that can learn commands
The learning eye
Direct-access
buttons
Items in the Device
menu
Left and Right
buttons