Additional Mouse Synchronization Procedures; Windows - ATEN CL5708I User Manual

CL5708I / CL5716I User Manual

Additional Mouse Synchronization Procedures

If you use Manual Mouse Synchronization, you should perform the following
operations on the servers that connect to the switch.
Note: 1. These procedures are to be performed on the servers attached to the
switch's ports - not on the client computer you are using to access the
KVM over IP switch.
2. In order for the local and remote mice to synchronize, you must use
the generic mouse driver supplied with the Windows operating
system. If you have a third party driver installed - such as one
supplied by the mouse manufacturer - you must remove it.

Windows:

1. Windows 2000:
a) Open the Mouse Properties dialog box (Control Panel
Mouse Properties)
b) Click the Motion tab
c) Set the mouse speed to the middle position (6 units in from the left)
d) Set the mouse acceleration to None
224
→ →
Mouse