Step 4: Mount Or Place The Switch; Mount The Switch In A Rack - NETGEAR GS724TPv2 Hardware Installation Manual

GS724TPv2 ProSAFE 24-Port Gigabit Smart Managed Switch with PoE+ and 2 SFP Ports
To check the package contents:
1. Place the container on a clean flat surface, and cut all straps securing the container.
2. Unpack the hardware from the boxes by carefully removing the hardware and placing it on a secure
and clean surface.
3. Remove all packing material.
4. Verify that the package contains the following items:
a. Switch
b. Power cord
c. Rubber footpads for tabletop installation
d. Rubber protection caps, which are already installed in the SFP sockets. If you install an SFP
transceiver module, you must remove the cap from the SFP socket.
e. Screws for rack mounting
f. Brackets for rack mounting
g. Installation guide
h. Resource CD with NETGEAR Smart Control Center utility
5. If any item is missing or damaged, contact your local NETGEAR reseller for replacement.

Step 4: Mount or Place the Switch

You can mount the switch in a standard 19-inch (48.26-centimeter) network equipment rack or place the
switch on a flat surface.

Mount the Switch in a Rack

To install the switch in a rack, you need the 19-inch rack-mount kit supplied with the switch.
To install the switch in a rack:
1. Attach the supplied mounting brackets to the side of the switch.
2. Insert the screws provided in the product package through each bracket and into the bracket mounting
holes in the switch.
3. Tighten the screws with a No. 2 Phillips screwdriver to secure each bracket.
Installation
17