Step 6: Attach Devices; Step 7: Check The Installation - NETGEAR GS724TPv2 Hardware Installation Manual

GS724TPv2 ProSAFE 24-Port Gigabit Smart Managed Switch with PoE+ and 2 SFP Ports
To install an SFP transceiver module:
1. Insert the transceiver into the SFP port.
Use port 25F or 26F.
2. Press firmly on the flange of the module to seat it securely into the connector.

Step 6: Attach Devices

All RJ-45 ports on the switch support PoE+. For application examples and information about PoE, see
Applications on page 21.
To attach devices:
1. Attach PoE and non-PoE devices to the switch.
2. Verify that all cables are installed correctly.

Step 7: Check the Installation

Before you apply power to the switch, perform the steps that are described in this section.
To check the installation:
1. Inspect the equipment thoroughly.
2. Verify again that all cables are installed correctly.
Installation
19