MAINTENANCE
Figure 7-10 Remote Mount Enhanced Control Head with Remote Head Enhanced
Remote Head Enhanced - Reassembly
To Reassemble the Remote Front Housing:
1.
Connect the flex from the Remote Head Enhanced to the top small connector in the
ceiver.
NOTE:
For correct orientation of the flex in the Transceiver, the "plastic" tab should be up,
contacts facing down. Align the 'dot' or 'O' marking on the flex with the 'O' mark on
the Transceiver. The
2.
Press the Remote Head Enhanced onto the Transceiver chassis until the chassis tabs
into place.
Remote Mount Enhanced Control Head - Disassembly
To Disassemble the Remote Mount Enhanced Control Head:
1.
Unscrew the wing screws of the remote trunnion and remove the remote trunnion from the
Remote Mount Enhanced Control Head.
2.
Unscrew the middle screw from the back housing.
3.
Remove the back housing by inserting the dismantling tool (Part No. 6686119B01) in the
recess between the back housing and Remote Mount Enhanced Control Head front housing.
Remote Back Housing
Remote Head Enhanced
Remote Back Head
flex must be pushed into the connector until it meets the stop
7 - 15
Trans-
.
snap