Linksys LGS308 User Manual page 41

3. Enter the parameters.
• Filter Name—Enter a name between 0-30 characters.
Filter Object—Select the node in the MIB tree that is included or excluded in the
•
selected SNMP filter. The options to select the object are as follows:
4. Include or exclude in Object Filter. If this is selected, the selected MIBs are included in the
filter, otherwise they are excluded.
5. Click Apply. The SNMP views are defined and the running configuration is updated.
V1/V2 Notification Recipients
Trap messages are generated to report system events, as defined in RFC 1215. The system can
generate traps defined in the MIB that it supports.
Trap receivers (aka Notification Recipients) are network nodes where the trap messages are sent
by the device. A list of notification recipients are defined as the targets of trap messages.
A trap receiver entry contains the IP address of the node and the SNMP credentials
corresponding to the version that is included in the trap message. When an event arises that
requires a trap message to be sent, it is sent to every node listed in the Notification Recipient
Table.
o Selection List—Enables you to navigate the MIB tree. Press the Up arrow
to go to the level of the selected node's parent and siblings; press the Down
arrow to descend to the level of the selected node's children. Click nodes in
the view to pass from one node to its sibling. Use the scrollbar to bring
siblings in view.
o If Object ID is used, the object identifier is included in the view if the Include
in filter option is selected.
41