Linksys LGS308 User Manual page 196

• Boot Code—Controls the basic system startup and launches the firmware image.
• Source File Name—Enter the name of the source file.
TFTP Server—Select whether to specify the TFTP server by IP address or domain
•
name.
IP Version—Select whether an IPv4 or an IPv6 address is used.
•
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are
as follows:
o Link Local—The IPv6 address uniquely identifies hosts on a single network
link. A link local address has a prefix of FE80, is not routable, and can be
used for communication only on the local network. Only one link local
address is supported. If a link local address exists on the interface, this
entry replaces the address in the configuration.
o Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
o Interface—Select the link local interface (if IPv6 is used) from the list.
TFTP Server IP Address—Enter the IP address of the TFTP server.
•
• TFTP Server Name—Enter the domain name of the TFTP server.
4. If you selected via HTTP/HTTPS, you can only upgrade.
Click Browse to select a file or enter the path and source file name to be used in the
transfer.
5. Click Apply.
Note—When the process is complete, the following information is displayed.
• Bytes Transferred—How many bites were transferred in the process.
Status—Did the process succeed or fail.
•
• Error Message—Reason for failure of the process.
196