Linksys LGS310C Quick Start Manual

Available languages

Download this manual

Rackmount Installation

To rack-mount the switch in any standard 19-inch wide, 1U high rack:

1) Place the switch on a hard flat surface with the front panel facing you.

Using the supplied screws, attach rack-mount brackets to either side of the switch and

secure tightly.

Attaching the brackets

After the brackets are attached, use supplied screws to securely attach the brackets

to any standard 19-inch rack.

Technical Support, Regulatory, Safety and Warranty

Information about Linksys Business Products can be found at www.linksys.com/support

Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply

a partnership relationship between Linksys or any of its affiliates and any other company.

Mounting in Rack

8820-03073 Rev. B00

LGS310C / LGS310MPC

LGS328C / LGS328MPC / LGS328PC

LGS352C / LGS352MPC

Managed Switches

Quick Start Guide

網管交換機快速入門指南

以太网交换机快速入门指南

Need help?

Do you have a question about the LGS310C and is the answer not in the manual?

Page 1 Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Linksys or any of its affiliates and any other company. 2021 Linksys Holdings, Inc. and/or its affiliates. All rights reserved.
Page 4 1) 将交换机放置在坚硬、平坦的表面上，使前面板朝向您的方向。 2) 使用附带的螺钉，将机架式安装托架安装到交换机的两侧并拧紧。 3) 安装托架后，使用附带的螺钉将托架牢固地安装到任何标准 19 英寸机架上。长按不超过 10 秒可重新启动交换机。长按 10 秒以上可将交换机重置为出厂设置。技术支持、监管、安全和保修有关 Linksys 商用产品的信息，可访问 www.linksys.com/support 自动感应以太网端口检测与其连接的设备的速度 (10 Mbps、100 Mbps 或 1000 Mbps)，所提及的第三方商标是其各自所有者的财产。使用“合作伙伴”一词并非暗指合作伙伴关系Linksys或其任何附属公司与任何其他公司的关系并相应地调整端口速度和双工传输。 2021 Linksys Holdings, Inc. 和/或其附属公司。保留所有权利 SFP/SFP+ (miniGBIC) 扩展模块的连接点，允许交换机通过光纤向上传输到另一台交换机。 SFP/SFP+ 端口以 1G/10G 的速度提供到高速网段或单个工作站的链路。...

Lgs310mpcLgs328cLgs328mpcLgs328pcLgs352cLgs352mpc