Table of Contents
Advertisement
Operation
The master
fixture becomes
Master when in
AUTO mode.
AUTO 01~10
are fully
configured
programs and
you cannot modify them.
However, you can edit PR
01~10 programs (see Edit
Custom).
10
Master/Slave
On the Master unit:
1.
Go to MENU > RUN and select dMx.
2.
Go to MENU > AUTO and select any Auto or Custom program. You may also go
to MENU > STAT and manually set the color values (see Static Colors).
On each of the Slave units:
3.
Go to MENU > RUN and select SLAV.
The slave fixtures will follow the program played by the Master.
Static Colors
1.
Go to MENU > STAT.
2.
Select a color or effect (R, G, b, w, or ST).
3.
Select a color value (000~255) or a strobe frequency (0~20).
Auto Play
1.
Go to MENU > AUTO.
2.
Select a program (AT 01~10 or PR 01~10).
Edit Custom
1.
Go to MENU > EdIT.
2.
Select a program (PR 01~10).
3.
Select a scene (SC 01~30).
4.
Select a color, strobe, or timers (R, G, b, w, Sb, T, or F).
5.
Configure the color value (0~255).
6.
Repeat steps 4 and 5 for the other colors.
7.
Configure the strobe frequency (0~20).
8.
Configure the Step and Fade timers (0~255).
9.
Repeat steps 4 to 8 for the other scenes.
Whites Setting
1.
Go to MENU > CAL1.
2.
Select a white color (wT 1~11).
3.
Select an RGB color (R, G, b, or w).
4.
Configure the color value (0~255).
5.
Repeat steps 3 and 4 for the other RGBW colors to obtain a white color.
6.
Repeat steps 2 to 5 for the other white colors.
RGB to White Setting
1.
Go to MENU > CAL2 > RGbw.
2.
Select an RGB color (R, G, or b).
3.
Configure the color value (0~255).
4.
Repeat steps 2 and 3 for the other RGB colors to obtain a white color.
Ilumipod 42 IP Optic Series User Manual Rev. 6
Advertisement
Table of Contents
