HPE 6127XLG Irf Configuration Manual page 22

To bind physical interfaces to IRF ports:
Step
1. Enter system view.
2. Enter interface view or
interface range view.
3. Shut down the interface or
the range of interfaces.
4. Return to system view.
5. Enter IRF port view.
6. Bind each physical
interface to the IRF port.
7. Return to system view.
8. Enter interface view or
interface range view.
9. Bring up the interface or
the range of interfaces.
10. Return to system view.
11. Save the configuration.
12. Activate the IRF port
settings.
Command
system-view
•
Enter interface range view:
interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-24>
•
Enter interface view:
interface interface-type
interface-number
shutdown
quit
irf-port member-id/port-number
port group interface interface-type
interface-number
quit
•
Enter interface range view:
interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-24>
•
Enter interface view:
interface interface-type
interface-number
undo shutdown
quit
save
irf-port-configuration active
18
Remarks
N/A
To shut down a range of IRF
physical interfaces, enter
interface range view.
To shut down one IRF physical
interface, enter its interface view.
By default, all interfaces are up.
N/A
N/A
By default, no physical interfaces
are bound to any IRF port.
Repeat this step to assign
multiple physical interfaces to
the IRF port for link redundancy.
You can bind up to four physical
interfaces to an IRF port.
N/A
N/A
N/A
N/A
Activating IRF port settings
causes IRF merge and reboot.
To avoid data loss, save the
running configuration to the
startup configuration file before
you perform the operation.
After this step is performed, the
state of the IRF port changes to
UP, the member devices elect a
master automatically, and the
subordinate device reboots
automatically.
After the IRF fabric is formed,
you can add additional physical
interfaces to an IRF port (in UP
state) without repeating this step.