Table of Contents
Advertisement
The two devices perform master election, and the one that has failed the election reboots to
form an IRF fabric with the master.
3.
Configure Device C:
# Change the member ID of Device C to 3 and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 3
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
<Sysname> reboot
# Connect Device C to Device A as shown in
shown.)
# Shut down the physical interfaces used for IRF links.
<Sysname> system-view
[Sysname] interface range fortygige 3/1/1 to fortygige 3/1/2
[Sysname-if-range] shutdown
[Sysname-if-range] quit
# Bind FortyGigE 3/1/1 to IRF-port 3/1.
[Sysname] irf-port 3/1
[Sysname-irf-port3/1] port group interface fortygige 3/1/1
[Sysname-irf-port3/1] quit
# Bind FortyGigE 3/1/2 to IRF-port 3/2.
[Sysname] irf-port 3/2
[Sysname-irf-port3/2] port group interface fortygige 3/1/2
[Sysname-irf-port3/2] quit
# Bring up the physical interfaces and save the configuration.
[Sysname] interface range fortygige 3/1/1 to fortygige 3/1/2
[Sysname-if-range] undo shutdown
[Sysname-if-range] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
Device C reboots to join the IRF fabric.
4.
Configure Device D:
# Change the member ID of Device D to 4 and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 4
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
<Sysname> reboot
# Connect Device D to Device B and Device C as shown in
(Details not shown.)
# Shut down the physical interfaces used for IRF links.
<Sysname> system-view
[Sysname] interface range fortygige 4/1/1 to fortygige 4/1/2
[Sysname-if-range] shutdown
[Sysname-if-range] quit
# Bind FortyGigE 4/1/1 to IRF-port 4/1.
[Sysname] irf-port 4/1
Figure
19, and log in to Device C. (Details not
41
Figure
19, and log in to Device D.
Advertisement
Table of Contents
