Configuring Nd Mad - HPE 6127XLG Irf Configuration Manual

Step

Configuring ND MAD

ND MAD can use only common Ethernet ports.
When you use ND MAD, follow these restrictions and guidelines:
•
Do not configure ND MAD on VLAN-interface 1.
•
Do not use the VLAN configured for ND MAD for any other purposes.
•
If an intermediate device is used, you can use data links as ND MAD links. If no intermediate
device is used, set up dedicated ND MAD links between IRF member devices.
•
If an intermediate device is used, make sure the following requirements are met:
Run the spanning tree feature between the IRF fabric and the intermediate device. Make

sure there is only one ND MAD link in forwarding state. For more information about the
spanning tree feature and its configuration, see Layer 2—LAN Switching Configuration
Guide.
Enable the IRF fabric to change its bridge MAC address as soon as the address owner

leaves.
Create an ND MAD VLAN and assign the ports on the ND MAD links to the VLAN.

If the intermediate device is also an IRF fabric, assign the two IRF fabrics different domain

IDs for correct split detection.
To configure ND MAD:
Step
1. Enter system view.
2. Assign a domain ID to the
IRF fabric.
3. Configure the IRF bridge
MAC address to change as
soon as the address owner
leaves.
4. Create a VLAN dedicated to
ND MAD.
5. Return to system view.
6. Enter Ethernet interface
view.
7. Assign the port to the ND
MAD VLAN.
8. Return to system view.
9. Create the VLAN interface
Command
Command
system-view
irf domain domain-id
undo irf mac-address persistent
vlan vlan-id
quit
interface interface-type
interface-number
•
Assign the port to the VLAN as
an access port:
port access vlan vlan-id
•
Assign the port to the VLAN as a
trunk port:
port trunk permit vlan vlan-id
•
Assign the port to the VLAN as a
hybrid port:
port hybrid vlan vlan-id
{ tagged | untagged }
quit
interface vlan-interface
27
Remarks
disabled.
Remarks
N/A
The default IRF domain ID is 0.
By default, the IRF bridge MAC
address remains unchanged for
6 minutes after the address
owner leaves.
The default VLAN on the device
is VLAN 1.
N/A
N/A
The link type of ND MAD ports
can be access, trunk, or hybrid.
The default link type of a port is
access.
N/A
N/A