Advanced - RCA DWG855 User Manual

Chapter 2: Web Configuration

5. Advanced

This page allows you to configure some advanced settings. The factory default values should provide
good results in most cases. We don't recommend you change these settings unless you have technical
knowledge of 802.11b wireless technology.
For expert users, details of all settings on this web page are provided below.
Fig. 44 Gateway\Wireless\Advanced
Beacon Interval:
Set the period of beacon transmissions to allow mobile stations to locate and identify a BSS. The
measure unit is "time units" (TU) of 1024 microseconds. (Value range: 1~65535)
DTIM Interval:
The value you set here is used to inform mobile stations when multicast frames that have been buffered
at the Wireless Gateway will be delivered and how often that delivery occurs. (Value range: 1~255)
Fragmentation Threshold:
Set the number of the fragmenting frames to make the data to be delivered without errors induced by the
interference. Frames longer than the value you set here are fragmented before the initial transmission
into fragments no longer than the value of the threshold. (Value range: 256~ 2346)
RTS Threshold:
Set the value for sending a request to the destination. All the frames of a length greater than the threshold
that you set here will be sent with the four-way frame exchange. And, a length less than or equal to the
value that you set will not be proceeded by RTS. (Value range: 0~ 2347)
54gTM Network Mode:
There are three modes for you to choose, please check the specification of your wireless card and choose
55
Illustrations contained in this document are for representation only.