Rear Panel
TEL1 & TEL2
ETHERNET 1-4:
REBOOT EMTA:
CABLE:
15VDC:
Installing the Battery
This section provides information on installing batteries into the modem. Follow the steps below:
1. Ensure the power cord is unplugged.
2. Remove the battery cover on the rear panel. There are two battery compartments. You may install
a single battery into either compartment.
Illustrations contained in this document are for representation only.
Chapter 1: Connections and Setup
Telephony RJ-11 connector
Ethernet 10/100BaseT RJ-45 connector
Reboot this Residential Voice Gateway
F-Connector
Power connector
9