Assembly - Gravely pro-turn 460 diesel 992236 Operator's Manual

ASSEMBLY

WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
UNIT ASSEMBLY
Package Contents
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit – Remove wrap and
packaging materials.
2. Remove Unit From Container – Open
bypass valves (See To Push The Unit on
page 23).
3. Push unit from container onto a level
surface.
4. Close the bypass valves.
5. Check Tire Pressures – See
Specifications on page 47.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment
and experience to perform the
job.
• Do not inflate the tires above the
recommended pressure.
• Do not stand in front or over the
tire assembly when inflating.
Use a clip-on chuck and
extension hose long enough to
allow you to stand to one side.
6. Locate anti-rattle knobs in literature pack
and install in ROPS uprights on both
sides. Raise Rollover Protection Structure
(ROPS) center bar – See Rollover
Protection Structure (ROPS) on page 16.
7. Adjust Seat – See Seat Adjustments on
page 20 and Service Position on
page 27.
8. Check Steering Lever Positions – See
Adjusting the Parking Brake on page 37.
9. Charge Battery – Remove battery from
unit and charge (See Battery on
page 33).
10. Check Engine Oil Level – Check and add
oil if needed. See engine manual for
specifications.
11. Check Hydraulic Fluid Level – Check and
add oil if needed. See Check Hydraulic
Fluid Level on page 28.
12. Check Coolant Level
13. Fill Engine Fuel Tank – Add clean fuel to
the fuel tank. See Filling Fuel Tank on
page 21.
IMPORTANT: Refer to engine manual for fuel
type.
14. Inspect Hardware – Check for loose
hardware.
15. Check Safety Interlock System – Check
to see that the interlock system operates
correctly (See Safety Interlock System on
page 16).
WARNING: FAILURE OF
INTERLOCK together with
improper operation can result in
severe personal injury.
16. Lubrication – Lubricate all fittings per
maintenance label under seat and check
hydraulic oil level (See Maintenance
Schedule on page 24).
17. Remove the knob retaining the discharge
chute from the transport position and
place the discharge chute in the
operating position. Return and tighten
knob in original position on deck for
storage.
Prepare Seat
1. Remove hairpin and clevis from shipping
position on left side of seat and reinstall
as shown below.
EN - 13
Transport
Position
Operating
Position
Figure 3