Manual - Gravely pro-turn 460 diesel 992236 Operator's Manual

Clutch Anchor and
Mounting Hardware
2
6
3
4
1. Hydro Belt
2. Spring
3. Idler
4. Engine Sheave
5. Right Hand Hydrostat
6. Left Hand Hydrostat
7. Clutch
8. Clutch Anchor
Figure 35
1
5
7
8
EN - 40
MOWER DECKS
Anti-scalp Roller Adjustment
The anti-scalp rollers are set at the factory for
typical mowing height, but can be adjusted for
high or low cutting conditions (Figure 36).
Anti-Scalp rollers are intended to prevent
lawn scalping, not to control cutting height.
For a very high cutting height, set the anti-
scalp rollers in the lowest position on the
bracket.
For a very low cutting height, set the anti-
scalp rollers in the highest position on the
bracket.
NOTICE: There are two anti-scalp rollers on
the outside of the mower deck and two anti-
scalp rollers on the inside of the mower deck.
Make sure all anti-scalp rollers are set at the
same height.
1. Lowest Cutting Height
2. Highest Cutting Height
Figure 36
Deck Lift Pedal Adjustment
(Figure 37)
To adjust the foot pedal:
1. Remove the hex bolt securing the foot
pedal to the lift arm.
2. Move foot pedal to desired position.
3. Install hex bolt and torque to 71 – 95 N•m
(52 – 70 lb-ft).
1
2