Assembly - Gravely Promaster 44Z Owner's/Operator's Manual

ALWAYS block wheels and know all jack
stands are strong and secure and will hold
weight of unit during maintenance.
Release pressure slowly from components
with stored energy.
NEVER attempt to make any adjustments to
unit while engine is running (except where
specifically recommended). Stop engine,
remove key or spark plug wire and wait for all
moving parts to stop before servicing or
cleaning.
Check parking brake operation frequently.
Adjust and service as required.
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Maintain or replace safety and instruction
labels, as necessary.
NEVER store unit with fuel in fuel tank, inside
a building where any ignition sources are
present.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit - Remove shrink wrap and
packaging materials.
2. Remove Unit From Container - Open
Bypass Valves (dump valves) (See
Moving the Unit with the Engine Off on
page 15).
Push unit from container onto a level
surface. Close the bypass valves.
3. Tires - See Specifications on page 30 .
Shut off fuel and allow engine to cool
completely before storing in closed area or
covering unit.
Clean grass and debris from unit, especially
from around muffler and engine, to help
prevent fires.
For extended storage, shut off fuel and clean
unit thoroughly. See engine manual for proper
storage.
Lower cutting deck unless a positive
mechanical lock is used.
Use only attachments or accessories
designed for your unit.
Check all hardware at regular intervals,
especially blade attachment bolts. Keep all
hardware properly tightened.
Check attachment components frequently. If
worn or damaged, replace with
manufacturer's recommended parts.

ASSEMBLY

4. Seat - See Seat Adjustments on
page 13 and Service Position on
page 17.
5. Position Steering Levers - Rotate
eccentric spacers to align handlebars.
Tighten hardware securely. See Aligning
the Steering Levers (Figure 14) on
page 23.
6. Battery - Remove battery from unit and
charge (See Battery on page 21).
GB - 9
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
• Do not inflate the tires
above the recommended
pressure.
• Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
• Do not stand in front or over
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.