Gravely pro-turn 460 diesel 992236 Operator's Manual page 23

3. Engage the parking brake.
4. Lower the attachment.
5. Turn the ignition key to the Off position
and remove the key.
TO PUSH THE UNIT
Place the transaxles in bypass mode to move
the unit with the engine off.
NOTICE: Make sure both transaxles are set
to neutral before pushing the unit.
IMPORTANT: DO NOT tow the unit.
Transport the unit on an appropriate truck or
trailer.
1. Shut off engine.
2. Place seat in the service position (see
Service Position on page 27).
3. Turn the bypass valves a quarter-turn
clockwise to the bypass position.
WARNING: Do not bypass
transmission when on a slope.
4. Disengage parking brake.
5. Push unit to desired location.
6. Engage parking brake.
7. Turn the bypass valves a quarter-turn
counter-clockwise to the run position.
Bypass Position
Run Position
Figure 12
FOR BEST PERFORMANCE
• Cut grass when it is dry.
• Keep mower blades sharp.
• Keep mower deck properly leveled.
• Adjust anti-scalp rollers to prevent
scalping.
• Adjust the idler spring length as needed.
See Figure 34.
• Do not set height of cut too low. For very
tall grass, mow twice.
• Do not travel too fast.
• Mow with the engine set at full throttle.
• When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than
2.5 cm (1") at any one time.
• Discharge clippings into areas already
cut.
• Vary cutting pattern with each mowing.
• Do not allow grass or debris to collect
inside of mower deck. Clean after each
use.
EN - 23