Manual - Gravely pro-turn 460 diesel 992236 Operator's Manual

ALIGNING THE STEERING
LEVERS
Additional Steering Lever
Adjustments
(Figure 27)
1. Shut off engine. Remove the ignition key.
2. Place seat in the service position (See
Service Position on page 27).
3. Check that upper and lower steering
levers are aligned parallel to each other.
There should be a maximum of 3.2 mm
(1/8") difference between the top and the
bottom.
• If upper and lower steering arms are not
parallel, loosen mounting hardware,
reposition top lever and tighten hardware.
4. Disconnect the steering linkages from the
transaxle.
5. Engage parking brake.
6. Turn the eccentric spacer until the
steering levers align.
7. Loosen the jam nut at the bottom of the
tie rod and then turn the ball joint to align
it with the transaxle control arm, and then
connect the linkage to the control arm.
1
2
1. Upper Steering Lever
2. Lower Steering Lever
3. Eccentric Spacer
Figure 27
Align upper and lower
steering levers so
that top dimension is
within 3.2 mm (1/8")
of bottom.
3
Adjust Forward Position
(Figure 28)
1. Shut off engine. Remove the ignition key.
2. Loosen pivot bolt and angle adjustment
bolt.
3. Rotate the steering lever assembly to
desired forward lever position.
4. Tighten hardware.
IMPORTANT: Ensure that both levers are
aligned and do not make contact with each
other
Adjust Lever Height
(Figures 28 and 29)
1. Shut off engine. Remove the ignition key.
2. Remove pivot bolt and angle adjustment
bolt from steering lever assembly and
remove steering lever assembly.
3. Position the steering lever assembly to
use the upper and middle holes for
highest steering lever position.
4. Position the steering lever assembly to
used the middle and lower holes for the
lowest steering lever position.
IMPORTANT: Ensure that both levers are
aligned and do not make contact with each
other.
1
2
3
1. Pivot Bolt (Upper Hole)
2. Angle Adjustment Bolt (Middle Hole)
3. Lower Hole
5. Adjust eccentric spacers so steering
levers are at equal height with a
1.27 – 2.54 cm (1/2 – 1") gap between
them (Figure 29).
EN - 36
Figure 28