Installation Guide
Mounting the Network Jack
After connecting the Network Jack to the network, use the two
provided screws to mount the Network Jack in any standard
NEMA-WD6 cubicle opening or wall outlet.
If the cubicle or wall opening has a depth of fewer than five
inches, does not support the NEMA-WD6 standard, or does not
have pre-drilled screw holes, mount the Network Jack using the
extension ring, as shown below.
Wall
1.5"
Standard
wall mount
NOTE: Make sure the vents along the edges of the
Network Jack faceplate are clear of any obstructions.
22
Wall
Extension ring
1.2"
.3"
Extension ring
wall mount