Installation Guide
Component
Purpose
VoIP telephone
For powering a VoIP telephone on a
power cable
network that uses Capacitive Power
Discovery Process-compatible Power
Over Ethernet.
Network Jack
For verifying the Network Jack
Tester
installation; useful if installing
multiple Network Jacks.
Installing the Network Jack
Installing the Network Jack consists of the following steps:
1 Set up the power supply (page 10).
2 Set the Power Over Ethernet dip switches (page 13;
optional, required only if your network supports Power
Over Ethernet or if you are using a single-port or multi-port
power supply).
3 Install the adapter plate and pass-through ports (page 15;
optional).
4 Plan the installation (page 17).
5 Set up the network cabling at your site (page 19).
6 Connect the Network Jack to the network (page 19).
7 Mount the Network Jack to the wall or office cubicle
(page 22).
8
3C Number(s)
Check the 3Com
web site
3CNJTESTER