Flashforge Finder User Manual page 19

Filament Check Off
The filament detection is turned off.
Note: Filament exhausted or interrupted
cannot be detected.The print job can still
work normally when filament is not set into
the filament cartridge.
Power Saving Mode On
The power saving mode status is turned on. If
there is no operation within half an hour, the
printer will automatically shut down.(Power
saving mode will not work in the process of
printing)
Power Saving Mode Off
The power saving mode status is turned off.
Automatically shut down will not work.
Status:
It displays the real-time status of the extruder
temperature, fan and filament.
Finder User Guide | www.flashforge.com 400-699-1063
19