Table of Contents
Advertisement
GENERAL NOTES & INFORMATION
READ ALL INFORMATION PROVIDED IN THIS GUIDE
BEFORE ATTEMPTING TO INSTALL THIS PRODUCT
The installation of this heating product must be in accordance with both the
manufacturer's instructions, and the regulations of the authority having
jurisdiction. Failure to do so will result in a voided warranty.
Caution must be taken to guard against risk of electric shock, fire, and bodily
injury during installation of this product.
All floors & subfloors should be prepared in accordance to ANSI & TCNA
specifications. All masonry, adhesives, moisture barriers, and bonding
agents used in the installation must be fully cured (per the manufacturer's
recommendations - but not less than 28 days) prior to energizing the product
for the first time. All components must be recognized and rated for their use.
NEVER OVERLAP, LAYER, OR STACK THE HEATING FILM ON TOP OF
The installation of this heating product must always be connected to a
DEDICATED electrical circuit.
The system shall be installed with a disconnecting means.
The system should always be disconnected from its power source during
service. This includes service to the thermostat.
All systems MUST be installed with a GFCI compliant thermostat or breaker.
The supply wire or terminals cannot be repaired. If the wire or terminal is
damaged, it must be replaced.
The National Electric Code does not allow the placement of nails, staples, or
other fasteners through the carbon heating or copper bus bar zones.
If a nail or staple is accidentally placed through this area, they must be
removed and securely taped shut.
S E C T I O N 1
1
PAGE 4
ANOTHER PIECE OF THE HEATING FILM.
EverWarm Radiant Heat
Advertisement
Table of Contents
