Table of Contents
Advertisement
THIN-SET 3/8"
HEATING FILM
SLAB
1. Prepare the Heating Film according to the steps in the General
Installation Instructions beginning on page #24.
2. Adhere the Heating Film to the slab or sub-floor using a moisture
resistant or water proofing indoor/outdoor flooring adhesive by rolling
back 1/2 a sheet at a time, using a 3/16"-1/4" (5-6mm) V-notch trowel to
apply adhesive to the floor, setting the Heating Film down onto
3. the adhesive. Using a roller, apply a continuous, even pressure with
overlapping strokes making a permanent bond between the sub-floor
and film.
4. Follow the manufacturer's recommended drying time for the membrane
you use before starting the tile installation.
5. Install the tile on top of the Heating Film using an unmodified thin-set
mortar meeting the requirements of ANSI A118.1 to install ceramic and
stone tile. (See notes)
FLOOR SENSOR (INCLUDED WITH ALL THERMOSTATS)
S E C T I O N 3
1
PAGE 16
TILE INSTALLATION
(WET AREA)
SLAB OR PLYWOOD SUBFLOOR
OR
MUST BE PROPERLY INSTALLED.
GROUT
JOIST 16" O.C. TYP.
EverWarm Radiant Floors
TILE / SLATE / STONE
MOISTURE RESISTANT
ADHESIVE
PLYWOOD SUBFLOOR
Advertisement
Table of Contents
