Table of Contents
Advertisement
INSTALLING EVERWARM KITS
(Kit description: TYPE - SQUARE FOOTAGE- VOLTAGE, Example: EverWarm Kit-15 square feet-120 volt system.)
1. Carefully plan the layout of the Heating Film for the installation.
2. Cut the Heating Film to the required length and dimension.
3. Seal the end that has been cut, by applying the narrow (2.4" inches wide)
Edge Sealing Tape.
4. There are two (2) wires that protrude approximately one (1) inch from the
end of the pre-assembled, attached, and pre-taped wire Harness. These are
used for adding another sheet of Heating Film. If you are adding a second
sheet to your system please refer to Harness, Adders, and Jumpers located
in the General Installation Instructions beginning on page #24. If you are not
adding a second sheet then proceed to the next step.
5. Check the OHMs reading (see pg #28 in this Guide).
6. A floor sensor MUST be installed and is included with the thermostat
(See pg #31 in this Guide).
7. After completing these steps please turn to the following sections for each
specific floor application:
Ceramic Tile, Stone, or Slate
Laminat W
e
Nail Down Wood
Carpet
Vinyl or Linoleum
8. Install the thermostat according to the manufacturer's instructions.
EverWarm Radiant Floors
CHK-15-120, CHK-25-120
The per-assembled radiant heat flooring
system is designed with ease of installation
in mind. These kits feature a per-attached
Harness, sealed with our Edge Sealing
Tape. This Kit also features a second,
narrower piece of Edge Sealing Tape for
sealing any edges or holes that are
intentionally cut during the installation.
ood
Page #13-16
Page #17
Page #18
Page #19
Page #20
S E C T I O N 4
PAGE 21
Advertisement
Table of Contents
