Table of Contents
Advertisement
INSTALLING THE FLOOR SENSOR AND RUNNING THE
COLD LEADS UP WALL
Each thermostat includes a floor sensor. Install the sensor perpendicular to
the wall at least 12 inches from the wall and not near other sources of heat.
The sensor MUST be either mounted on one of the white, non- heat
producing strips or placed BETWEEN sheets of Heating Film. Do NOT
place floor sensor directly on the heating area. The sensor should be taped
to the sheet using a piece of Edge Sealing Tape. The sensor wire is to be
run to the conduit and up to the thermostat junction box. It is not uncommon
to route a channel across the non-heat generating areas within the sub-floor
so that the sensor is in a more level position to aid with the subsequent
installation of the floor covering.
NOTE: CHECK WITH YOUR FLOORING MANUFACTURER FOR MAXIMUM
TEMPERATURE RATING THAT IS APPROPRIATE FOR YOUR FLOORING AND SET
YOUR THERMOSTAT ACCORDINGLY.
S E C T I O N 5
EverWarm Radiant Floors
PAGE 31
Advertisement
Table of Contents
