Linoleum And Vinyl - Everwarm CHK-15-120 Installation Manual

LINOLEUM AND VINYL INSTALLATION
GLUE/ADHESIVE
GLUE/ADHESIVE
SLAB
1. Prepare the Heating Film according to the process outlined in the
General Installation Instructions beginning on page #24.
2. Adhere the Heating Film to the slab or sub-floor using a moisture
resistant or water proofing indoor/outdoor flooring adhesive by rolling
back 1/2 a sheet at a time, using a 3/16"-1/4"(5-6mm) V-notch trowel
to apply adhesive to the floor, setting the Heating Film down onto the
adhesive. Using a roller, apply a continuous, even pressure with
overlapping strokes making a permanent bond between the sub-floor
and film.
3. Install the linoleum or vinyl flooring according to the manufacturer's
specifications.
NOTE: CHECK WITH THE FLOORING MANUFACTURER FOR MAXIMUM
TEMPERATURE RATINGS THAT ARE APPROPRIATE FOR YOUR FLOORING AND
FLOOR SENSOR (INCLUDED WITH ALL THERMOSTATS)
S E C T I O N 3
1
PAGE 20
OR
SET THE THERMOSTAT ACCORDINGLY.
MUST BE PROPERLY INSTALLED.
FLOORING
HEATING FILM
THERMAL BARRIER (OPTIONAL)
PLYWOOD SUBFLOOR
JOIST 16" O.C. TYP.
EverWarm Radiant Floors